ty for my new RKE!
|
|
|
ty for my new RKE!
dang I was just up in carlsbad yesterday... I should have thought to reschedule my trip to pick up both of these on the same day
Are you available for weekend pick up?
on the ph probe do i just pull it out of the liquid cap and put it in my tank? i dont wanna mess my probe up... =P
Yes you remove the endcap. The probe needs to remain wet and there is a little bit of fluid in the cap to keep it moist. You will need to calibrate the probe before it will read correctly.
Dave
My current 130g system
Got a question about controllers? Ask away...
Digital Aquatics beta tester
there were no explicit directions in the manual for calibration... i know i have a 7.0 ph and a 10.0 ph pack both with temp corrections on the back... but nothing more than that... =/...
would you like to walk me thru it Dave?
How did the calibration go?
Dave
My current 130g system
Got a question about controllers? Ask away...
Digital Aquatics beta tester
Thanks again... calibration worked well... and figured out that bug... ended up being a pc4 that was only firmware v1.10...
I'm having trouble with my temperature probe. I keep calibrating it based on a thermometer that I have from my lab. Then the temp will fluctuate wildly.. i'm talking up to 110 or down to 60 degrees farenheit. Any ideas on what is causing this? i left if for a while and now it just says iTemp error. I've read that stray voltage might cause this... has anyone had experience with this?
I also get an error when the temp probe is not even in the water. At this point I can't even calibrate it.. i just get an iTemp error.
Last edited by j1gregor; 07-11-2009 at 08:59 PM.
DaveMorris helped me out with my problems... try shooting him a PM...
PM sent to DaveMorris
PM replied. Call me and I will replace the probe with an extra that I have. I sent you my number in the PM.
Dave
My current 130g system
Got a question about controllers? Ask away...
Digital Aquatics beta tester
When you set the repeat count to 2, does that mean that it goes through the cycle you set up once, then repeats twice for a total of 3 cycles. Or is the repeat count the total number of cycles that it goes through. Thanks.
The count includes the first one.
Dave
My current 130g system
Got a question about controllers? Ask away...
Digital Aquatics beta tester
The RKL is back in stock, does anyone wanna do another GB?
There are currently 1 users browsing this thread. (0 members and 1 guests)