nothing, thats a good idea
|
|
|
nothing, thats a good idea
So Im figuring out hole sizes now. Im thinking 1.5 for the overflow to the sump, 1.5 for the intake to the closed loop and 3/4 for all returns. I was thinking about going with the three quarter because thats the biggest l could find for Loc-Line, and i want to be able to thread the Loc-Line directly into the bulkheads so that the size is compact. You think 3/4 returns are big enough? Two 3/4's for the CL return and one 3/4 for the sump return which is currently going to be mag 7 that I already have. The sump returns are going to go through one bulk head into a pvc pipe standing straight up about 18 inches. Im going to have 3 tees plumbed into the pipe for Loc-Line jets. What do you think?
are you sure you want your sump return that far below the water?Im going to have 3 tees plumbed into the pipe for Loc-Line jets.
Are you concerned of syphoning. I thouht about that, but the last return jet will run across the surface of the water, so if the water level drop more than 3/4 of an inch it will break the syphon.
Ahhh!!! Brilliant!!!
what do you think of those return sizes though, big enough, the tank is 24deepx30widex20tall
should be good w/that, what pump are you going to use?
i have a mag 7 for the sump return and a genx pcx 40 for the CL, although Im thinking about going with a diiferent pump, the genx is a little loud. Its fine now cause its plumbed into the garage but this next set up is going to have the pump in the stand.
sound like that shoul dgive you enough flow, how much are you getting from the gen-x after head loss?
You know Im really mot sure,,how would I measure that?
there is a good calculator @ RC
There are currently 1 users browsing this thread. (0 members and 1 guests)