Reef guard wave 2 pump (3D print?)

[nanoreef1]

Hello everyone I’m looking for some 3D printed guard for my pumps I have 2 of them so I need 2 scared that my high anemones getting in behind the pumps.

Can anyone make this in 3D print or point me to the right direction or know
someone that can make them? Any website makes them? Please let me know.. I could buy them or trade for some rainbow anemones. Don’t matter let me know.

Thanks, Hector


Sent from my iPhone using Tapatalk

[oceanslide]

Would the guards made for the Nero 5 fit?

[nanoreef1]

Would the guards made for the Nero 5 fit?

Not sure maybe since the Ai Nero pump copied the wave puck 2 by Waveline. Not sure Nero seems slightly smaller? Maybe could be modified.


Sent from my iPhone using Tapatalk

[seanmcknew]

I have 3 of the slw-20 nem guards can you measure the size of the outside diameter of the pump. Ill measure the inside of the ones I have.

Sent from my SM-G975U using Tapatalk

[seanmcknew]

2 7/8" and it would be a little loose 3" and it would not fit. $10 each

Sent from my SM-G975U using Tapatalk

[Drama D]

3D reefing art makes these. Hes on IG. I bought 3 of the nero5 versions off of him.

[nanoreef1]

3D reefing art makes these. Hes on IG. I bought 3 of the nero5 versions off of him.

Thanks brother I’ll check them out.


Sent from my iPhone using Tapatalk