This is the first time I’ll use an ro di system and I came upon this info and would like to know if this is recommended to do for every ro di system, I’m trying to make the filters last as long as possible. It’s a 4 stage brs ro di with tds Meter, if that matters.
“ Manufacturers recommend flushing new carbon block cartridges for at least 10 minutes before using the product water. Don’t run flush water through other stages in your system.
If you are using Catalytic GAC, or CGAC to treat chloramines, it is critical that you thoroughly rinse these cartridges. They will release fine black carbon dust when first installed. Don’t run this rinse water through later filter stages.
Manufacturers recommend flushing new RO membranes for up to 40 minutes to remove preservatives before using the product water. Don’t run flush water through other stages in your system.
Run 1.5 gallons of flush water through new DI resin before using the product water. Avoid contaminating (e.g., bacteria/mold/fungus) DI resin. Minimize storage time. Store DI resin in an airtight container to keep it moist until use. Store unused DI resin in an opaque container to avoid exposure to light. Clear shipping bags are appropriate for long term storage. Treat your resin gently! If resin is exposed to freezing temperatures during shipping, allow it to warm at room temperature for 24 hours prior to use.”