Hello everyone,
I am building a new stand for my tank to allow for a larger sump, and would like some advice. Below are my current specs (comments/recommendations welcome):
Current equipment:
60 gallon (about 48 x 16 x 18)
20 gallon sump
Rio+ Aqua 2500 return pump (about 700gph)
Circulation Pumps (2 x 600gph, 1 x 800gph, 1x525 gph)
ASM MINI G Protein Skimmer
Current USA Orbit Marine Aquarium LED Light, 48 to 60-Inch
300 watt heater
Live rock, sand, etc.
Livestock:
2 Clowns
2 Cardinalfish
1 Yellow Watchman Goby
2 Bar Gobys / Zebra Barred Dartfish
1 Sixline Wrasse
1 Pistol Shrimp
1 Fire Shrimp
1 Coral Banded Shrimp
Soft and LPS corals (15 - 20 small frags)
ADVICE #1: 55 gallon sump
I am going to swap out my 20 gallon DIY sump for a 55 gallon DIY sump, and use the same equipment. There will be about 18" of headroom between the top of the stand and the sump once enclosed. Is there anything I should consider if using a sump this large?
Advice 2: Wavemaker
Am considering this wavemaker:
Jebao RW-4 Wavemaker with Controller
http://www.amazon.com/gp/product/B00...=AA97WJUSQ1EKJ
Anyone using it? Should I opt for something else? Was probably going to replace my 800 GPH pump with it.
Advice 3: ATO
Am considering this ATO
http://www.amazon.com/gp/product/B00...=ATVPDKIKX0DER
Advice 4:
Thoughts on this RODI system:
http://www.amazon.com/Aquarium-II-St...s=RODI+7+stage
Advice 4:
Considering more fish after I upgrade the sump:
1. Midas Blenny
2. Flame Angel
3. TBD
I'll post photos of my current setup and in-progress stand.
Thanks in advance.