|
|
|
shouldnt the blue hose be your output? idk i do have rodi though
if not connected properly i am gueesing its incorrect on the 3rd canister or around that area
its hard to tell from the pics and I am no expert anyway on rodi i will ahave to look at mine otmorew
You go through the sediment to the carbon to the membrane to the DI and then you're good
Are you sure you have the TDS meter probes in the right tube? I get 400 to 500 at the the source. What are you reading on the inlet side? It is hard to tell from the pics. but the way its plumbed doesnt look right to me. They all work the same and are all plumbed the same. I would need to have it in front of me to check all your plumbing. Check out this link. https://www.buckeyehydro.com You have a 4 stage just follow their diagram and you should be ok. The red coming out of the RO membrane is your waste. the yellow needs to go into the di after the ro membrane...done. Did your system come with a pressure tank? With the flow restrictors and the shut off valve you have it looks like your unit came with parts to use a pressure tank.
Last edited by Sancho; 09-16-2014 at 04:05 PM.
was writing this when the site crashed^^^How do you plan on using this unit? will it be as needed , or will it be hooked up and able to make water all the time? If it is as needed plumbing is very simple. inlet to stage 1, stage 2. from stage 2 to ro membrane. the ro will have a waste and finished water. The finished water will go to the di resin.
Last edited by Sancho; 09-16-2014 at 04:27 PM.
I wont be using the unit all the time. I will hook it up to my hose periodically to make water. Right now my 125 is on hold because i cannot make water for it. I bought all new membranes for it and the di went from green to all black so i wonder if it is faulty or something went wrong. I have the hose running into the front of the sediment through the back and into the back of the carbon then through the front of the carbon to the ro membrane on top then out the middle outlet of the ro to the back of the di membrane and out the front of the di for my product and the bottom outlet is my flow restrictor 800 i believe... In the picture there is a while box on the inlet side of the ro membrane and i have no idea what that is so i took it off at first and my tds went up so i put it back on and idk how to plumb it... I am about to give up and purchase a new unit because i spent hours playing with this junk and it is still reading over 400 input and 300 something output. IS THERE ANYONE LOCAL THAT I CAN BRING IT OVER TO HELP ME OUT? haha
Thanks for the help guys!
I am looking for someone that can make me some rodi water that is close. I need about 60 gallons of 0 tds and i will pay AW h2o price for this and some to deliver. I have a 50 gallon water bin and many buckets that need to be filled so i can get my 120 gallon back up from the move! Let me know thanks.
Don't give up you going to run a bunch of water through it to cycle the filters first did you read what I posted
I see the flow restrictor laying there, but not connected to the waste line. Are you running it without the restrictor? It needs to be installed to run properly.
Everything else looks right as far as I can tell.
Restrictors are matched to the membranes output(GPD)
There are currently 1 users browsing this thread. (0 members and 1 guests)